Epson EB-W16SK - Images Appear Dark; Problems When Projection Starts; The Projector Does Not Turn on

Images appear dark
Check Remedy
Is it time to replace the lamp? When the lamp is nearly ready for replacement, the images become darker and the color quality becomes poorer. When
this happens, replace the lamp with a new lamp.
s "Replacing the Lamp" p.84
Is the polarizer attached? Brightness is reduced when the polarizer is attached. If the image is too dark when projecting 2D images, remove the
polarizer. Slide the polarizer horizontally, unhook the catch, and then pull it forward. You need to reattach the polarizer
to view 3D images.
Are you using the projector at a high altitude or in a location subject
to high temperatures?
The screen may become dark when using at high altitude or in a location subject to high temperatures. Although you
cannot make Power Consumption settings at this time, you can continue to use the projector.
Problems when Projection Starts
The projector does not turn on
Check Remedy
Did you press the [t] button? Press the [t] button to turn the power on.
Are the indicators switched off? The power cord is not connected correctly or power is not being supplied.
Disconnect and then reconnect the power cord.
s
"From Installation to Projection" p.32
Check that your electrical outlet or power source is functioning correctly.
Do the indicators turn on and off when the power cord is touched? There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power cable. If this
does not solve the problem, stop using the projector, disconnect the power cord from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
s Epson Projector Contact List
Is the Control Panel Lock set to Full Lock? Press the [t] button on the remote control. If you do not want to use Control Panel Lock, change the setting to Off.
s Settings - Control Panel Lock p.60
Is the correct setting for the remote receiver selected? Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.60
Problem Solving
77