Epson EB-W16SK - Switching to the Target Image by Remote Control

a
The following screen is displayed while no image signals are input.
Switching to the Target Image by Remote Control
You can change directly to the target image by pressing the following
buttons on the remote control.
Remote control
A
Switches to the image from the device connected to Computer1 or
Computer2.
B
Each time the button is pressed, it cycles through the images being input
from the following sources.
x S-Video port
x Video port
x HDMI port
C
This cannot be used while projecting in a stacked configuration.
D
This cannot be used on the projector.
Projecting Images
35