Problems Relating to Images
No images appear
Check Remedy
Did you press the [t] button? Press the [t] button to turn the power on.
Are the indicators switched off? The power cord is not connected correctly or power is not being supplied.
Connect the projector's power cord correctly.
s
"From Installation to Projection" p.32
Check that your electrical outlet or power source is functioning correctly.
Is A/V Mute active? Press the [A/V Mute] button on the remote control to cancel A/V Mute.
s "Hiding the Image and Sound Temporarily (A/V Mute)" p.45
Is the A/V mute slide closed? Open the A/V mute slide.
s "Front/Top" p.9
Is the image to be projected completely black?
(Only when projecting computer images)
Some input images, such as screen savers, may be completely black.
Is the image signal format setting correct?
(Only when projecting images from a video source)
Change the setting according to the signal for the connected equipment.
s Signal - Video Signal p.58
Is Monitor Out Port set to Monitor Out?When projecting images being input to the Monitor Out/Computer2 port, set the Monitor Out Port to Computer2
from the Configuration menu.
s Extended - Operation - Monitor Out Port p.61
Is a different device connected to the commander and the receiver?No image is displayed if the signals input to the commander and the receiver are from different devices. Connect the
device to the projectors correctly.
s "Connecting Equipment" p.21
Problem Solving
72
To Next Page
Loading...
