i
Change the computer's screen output.
When using a laptop computer, you need to change the screen
output from the computer. Hold down the Fn key (function key),
and press the b key.
a
x The method for changing differs depending on the computer being
used. See the documentation supplied with the computer.
x When turning off the projectors, press the commander's [t] button
on the control panel or remote control twice.
If the image is not projected, you can change the projected image using one
of the following methods.
x Press the [Source Search] button on the commander's control panel or
remote control.
s "Automatically Detect Input Signals and Change the Projected Image
(Source Search)" p.34
x Press the button for the target port on the remote control.
s "Switching to the Target Image by Remote Control" p.35
a
See the following when one of the projectors is not turned on, or if
you want to turn on only one of the projectors.
s "One of the projectors is not turned on, or the projectors have not
been linked together" p.78
s "Turning On One Projector in a Stacked Configuration" p.91
Automatically Detect Input Signals and Change
the Projected Image (Source Search)
Press the [Source Search] button to project images from the port currently
receiving an image.
Using the remote control Using the control panel
HDMI
*Computer2 is only available when Monitor Out Port is set to Computer2
from the Configuration menu.
When two or more image sources are connected, press the [Source Search]
button until the target image is projected.
When your video equipment is connected, start playback before beginning
this operation.
Projecting Images
34
To Next Page
Loading...
