Status Cause Remedy or Status
Lamp Error
Lamp Failure
Check the following two points.
x Take out the lamp and check if it is cracked.
s "Replacing the Lamp" p.84
x Clean the air filter.
s "Cleaning the Air Filter" p.83
If the lamp is not cracked: Reinstall the lamp and turn on the power.
If the error continues: Replace the lamp with a new one and then turn on the power.
If the error continues: Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest
address provided in the Epson Projector Contact List.
s Epson Projector Contact List
If the lamp is cracked: Contact your local dealer or the nearest address provided in the Epson Projector Contact List. (Images cannot be
projected until the lamp is replaced.)
s Epson Projector Contact List
When using at an altitude of 1500 m or more, set High Altitude Mode to On.
s "Extended Menu" p.61
Auto Iris Error
Power Err.
Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
s Epson Projector Contact List
High Temp Warning (This is not an abnormality. However, if the temperature rises too high again, projection stops automatically.)
x Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall.
x If the air filter is clogged, clean or replace it.
s "Cleaning the Air Filter" p.83
s "Replacing the Air Filter" p.88
Replace Lamp Replace it with a new lamp.
s "Replacing the Lamp" p.84
If you continue to use the lamp after the replacement period has passed, the possibility that the lamp may explode increases. Replace it with a
new lamp as soon as possible.
Problem Solving
69
To Next Page
Loading...
