Attention
x Make sure you install the lamp securely. If the lamp cover is removed, the
power turns off automatically as a safety precaution. If the lamp or the lamp
cover is not installed correctly, the power does not turn on.
x This product includes a lamp component that contains mercury (Hg). Please
consult your local regulations regarding disposal or recycling. Do not dispose
of it with normal waste.
Replacing the lamp for the receiver
a
After you turn off the projector's power and the confirmation
buzzer beeps twice, disconnect the power cord.
b
Remove the stacker angle adjustment screws.
c
Tilt back the commander section.
The steps from here on are the same as for replacing the commander's
lamp.
s "Replacing the lamp for the commander" p.85
Replacing Consumables
87
To Next Page
Loading...
