212 Setting Up Your Printer on a Network (EPL-6200)
❏ Use SelecType to set the Emulation Mode-AUX item to PS3.
Using the default Auto setting will cause an extra, unneeded
page to be printed.
❏ On the Device Settings sheet of the printer’s Properties dialog
box, make sure that SEND CTRL-D Before Each Job and
SEND CTRL-D After Each Job are set to No.
❏ TBCP (Tagged binary communications protocol) cannot be
used as the Output Protocol setting.
For Macintosh
Sharing the printer
This section describes how to share the printer on an AppleTalk
network.
The computers on the network can share the printer that is
directly connected to one of them. The computer that is directly
connected to the printer is the printer server, and the other
computers are the clients which need permission to share the
printer with the printer server. The clients share the printer via
the printer server.
Note for Mac OS X users:
This function is available only with Mac OS X 10.2 or later. To share
your printer on a network, use the Printer Sharing setting, which is a
standard feature of the Mac OS X 10.2 or later.
Setting up your printer as a shared printer
Follow these steps to share a printer connected directly to your
computer with other computers on an AppleTalk network.
To Next Page
Loading...
