Epson EPL-6200 - Resetting the Photoconductor Counter

Using the Remote Control Panel Utility (EPL-6200 only) 281
7
7
7
7
7
7
7
7
7
7
7
7
Note:
When the Print Mode in the printer driver is set to CRT, this setting is
not available.
Reset OPC Level
Click to reset the photoconductor unit life counter.
Note:
Reset the photoconductor counter when you replace the photoconductor
unit.
Resetting the photoconductor counter
After replacing the photoconductor unit, reset the
photoconductor counter.
You can reset these counter from the Remote Control Panel utility.
Resetting the photoconductor counter
Follow these steps to reset the photoconductor counter:
1. Access the Remote Control Panel utility.
2. Click Setting.