280 Using the Remote Control Panel Utility (EPL-6200 only)
Toner Out Error
Allows you to set whether the printer should continue or stop
printing when the printer encounters a Toner Out error. If set to
Continue (default), the printer continues printing regardless of
the error. This setting is recommended if you are physically
distant from the printer. If set to Stop, the printer stops printing
when it encounters the Toner Out error.
Auto Continue
Permits the printer to automatically recover from a Print Overrun,
Insufficient Memory for Current Task, or Change Paper error. The
printer continues printing within a few seconds after one of these
problems occurs.
When Auto Continue is off, you must press the N Start/Stop
button to resume printing. In most cases, leave Auto Continue
Disable (default) so you can tell when an error occurs and make
the necessary corrections. You might want to set Auto Continue
to Enable when printing long jobs or when you are away from
the printer for long periods.
Avoid Error
When printing complicated data (data which includes a lot of
words or graphics), a page error may occur because the printing
speed is faster than the image processing speed. To avoid the page
error, set the Avoid Error to On.
Note:
When this setting is On, the printing time may be long. When you do
not print complicated data, set this setting to Off (default).
Dot Correction
This setting is relevant to 1200 dpi printing only. When set to On,
the printing pattern of 1-dot lines is automatically corrected to
improve appearance.
To Next Page
Loading...
