Epson EPL-6200 - Page 324

Replacing Consumable Products 307
9
9
9
9
9
9
9
9
9
9
9
9
You need to replace the developer cartridge when a notice
message is displayed on the window of the EPSON Status
Monitor 3.
When the Toner light is on and the Error light is flashing slowly
on the EPL-6200 or the Ready light is on and the Error light is
flashing on the EPL-6200L, the printer has run out of toner. If the
indicator lights light up in this manner, or if a message is
displayed on the EPSON Status Monitor 3 screen, replace the
developer cartridge.
Always observe the following handling precautions when
replacing developer cartridges:
❏ Installing a genuine consumable product is recommended.
Using a non-genuine consumable product may affect print
quality. EPSON shall not be liable for any damages or
problems arising from the use of consumable products not
manufactured or approved by EPSON.
❏ When handling developer cartridges, always place them on
a clean, smooth surface.
❏ If you move a developer cartridge from a cool to a warm
environment, wait for at least one hour before installing it to
prevent damage from condensation.