398 Troubleshooting
The emulation mode is set to
something other than Auto or
PS3 for the interface that you
are using.
Change the mode setting to either Auto
or PS3.
Set the emulation mode using the
Remote Control Panel utility. For
details, see “Choosing printer
emulation” on page 262.
The printer does not print normally. (Windows 98/95 only)
Cause What to do
The computer is connected to
the printer via the parallel
interface and the parallel port
setting is set to the ECP mode.
The printer may not print normally if the
computer is connected to the printer via
the parallel interface and the ECP mode
is set. When this is the case, follow the
steps below to make sure that the mode
setting is correct:
(1) Click Start, select Settings, then click
Printers.
(2) Right-click the icon for the printer,
then click Properties.
(3) Click the Details tab, then click the
Spool Settings button.
(4) Select Disable bi-directional
support for this printer, then click the
OK button.
To Next Page
Loading...
