Troubleshooting 401
11
11
11
11
11
11
11
11
11
11
11
11
Problems printing via the parallel interface
The printer does not print normally via the parallel interface.
(Windows 98/95 only)
Cause What to do
The computer is connected to
the printer via the parallel
interface and the parallel port
setting is set to the ECP mode.
The printer may not print normally if the
computer is connected to the printer via
the parallel interface and the ECP mode
is set. When this is the case, follow the
steps below to make sure that the mode
setting is correct:
(1) Click Start, select Settings, then click
Printers.
(2) Right-click the icon for the printer,
then click Properties.
(3) Click the Details tab, then click the
Spool Settings button.
(4) Select Disable bi-directional
support for this printer, then click the
OK button.
To Next Page
Loading...
