Epson EPL-6200 - Page 420

Troubleshooting 403
11
11
11
11
11
11
11
11
11
11
11
11
The printer does not print normally via the network interface.
Cause What to do
The Data Format setting,
which is accessed by clicking
Advanced on the PostScript
sheet of the printer’s
Properties dialog box, is
different from the data format
setting specified in the
application.
If the file is created in an application that
allows you to change the data format or
encoding, such as Photoshop, make sure
that the setting in the application
matches that in the printer driver.
The computer is connected to
the network using AppleTalk
in a Windows NT 4.0/2000
environment, and the Send
CTRL+D Before Each Job or
Send CTRL+D After Each
Job setting on the Device
Settings sheet of the printer’s
Properties dialog box is set to
Yes.
Make sure that both the Send CTRL+D
Before Each Job and Send CTRL+D
After Each Job settings are set to No.
The network connection is
something other than
AppleTalk, and the Data
Format setting is not set to
ASCII data.
If the network connection is something
other than AppleTalk, make sure that
the Data Format setting is set to ASCII
data or Tagged binary
communications protocol.
The print data is too large. Click Advanced on the PostScript
sheet of the printer’s Properties dialog
box, and then change the Data Format
setting from ASCII data (default) to
Tagged binary communications
protocol.