12
Install the SCSI Interface Board
You must install your SCSI board before installing the scanner driver and software
applications.
If you have a Macintosh with a SCSI interface, or if you already have a SCSI board
installed in your PC, skip this section.
The SCSI board that came with your scanner is for PC
systems only. If your Macintosh does not have a SCSI
interface, please contact Apple
®
Computer, Inc. or Adaptec
for a compatible SCSI board.
For additional installation information, see the
Installation
Guide
that came with your SCSI board or your computer
documentation.
1. Turn off the computer and any peripheral devices. Unplug any power cords; then
disconnect all cables from the back panel of your computer.
2. Remove the cover from your computer.
Static electricity can damage electronic components. Ground
yourself before you touch any of the computer’s internal
components by touching an unpainted metal surface inside
the computer case.
3. Insert the interface board into an empty PCI expansion slot (refer to your
computer documentation for information about your PCI slots); then secure it
with the bracket screw.
4. Replace the computer cover and reconnect all cables.
5. Continue with the following section, “Unlock the Scanner.”
To Next Page
Loading...
