Epson Expression 800 - Software Problems

63
If you installed a ZIP drive. . .
Your ZIP drive may be interfering
with your scanner. Disable the ZIP
drive in the System Device Manager
in the Windows Control Panel, then
try using your scanner.
If you’re using a transparency unit
or auto document feeder. . .
■ Make sure the unit is correctly
installed and connected to the
scanner’s OPTION interface.
■ Make sure you’re selecting the
correct Document Source
(EPSON TWAIN Pro) or
Original (LaserSoft SilverFast
Lite) setting for your image.
Software Problems
If you can’t open the scanner
driver. . .
■ Check the cable connecting
the scanner to the computer.
Also, make sure the scanner’s
P
OPERATE
light is on. The
scanner must be turned on before
you start your computer. If
necessary, turn on the scanner
and restart your computer.
■ Check your SCSI board
installation (Windows only).
Make sure that the SCSI interface
board is installed correctly in your
computer. See page 12 for
installation instructions.
■ Check that your system recognizes
your scanner and SCSI board
(Windows only). Check System
Device Manager in the Windows
Control Panel. For Windows NT
4.0, check the SCSI Adapters
dialog in the Windows Control
Panel.
■ Check for conflicts in your SCSI
ID setting, I/O address, the
interrupt setting for your SCSI
board, and other settings. For
information about the SCSI ID
setting, see page 14. For
information about choosing other
settings, see your computer
manual.
■ Check your image source setting.
Make sure you selected
Expression 800
if you are using
LaserSoft or
EPSON TWAIN Pro
if you are using EPSON TWAIN
Pro.