Epson Expression 800 - Install EPSON TWAIN Pro; If Youre Running Windows

21
Install EPSON TWAIN Pro
Before you begin, make sure your SCSI board and SCSI driver are installed (Windows
users only) and the scanner is connected to your computer.
If You’re Running Windows
1. Turn on your scanner and wait for the READY light to come on. Then turn on
your computer and turn off any virus protection programs you’re using.
2. Insert the EPSON Expression 800 Scanning Tools CD-ROM in your drive.
3. Click Start, Run, then use the Browse function to go to
D:\Epson\TWAINPro\Disk1 (where D: is your CD-ROM drive). Select
Setup.exe and click Open, then click OK to run the installation program.
4. Follow the instructions on the screen to install EPSON TWAIN Pro and create
an EPSON Scanner program group.
5. After installing the software, click
Next to open the EPSON TWAIN
Pro Setup window.
6. If it’s not already selected, select SCSI
in the Interface listbox.
7. Windows automatically detects your
SCSI ID. If you’ve changed the SCSI
ID, select the new ID in the Port Id
listbox.
8. To test your scanner setup, place a
document face down on the
document table and close the scanner cover. Then click the
Test
button. After a
moment, the scanned image appears in the EPSON TWAIN Pro Setup window.
If the scanned image doesn’t appear, see “Problems and Solutions” for help.