23
If You’re Using a Macintosh. . .
1. Turn on your scanner and wait for the READY light to come on. Then turn on
your Macintosh and turn off any virus protection programs you’re using.
2. Insert the EPSON Expression 800 Scanning Tools CD-ROM in your drive.
3. Double-click the EXP800 CD-ROM icon to open the CD-ROM window, then
double-click the EPSON TWAIN Pro Installer icon.
4. At the first screen, click Install. The program installs EPSON TWAIN Pro and
creates an EPSON Scanner folder on your hard drive.
5. When you see the message that installation was successful, click Quit.
6. Open the EPSON Scanner folder on your hard drive and double-click the
EPSON Screen Calibration icon. The EPSON Screen Calibration utility starts.
You see the Screen Calibration window.
7. Move the slider until the shades of the horizontal gray stripes appear similar.
View the screen from a short distance. The gray stripes will not perfectly blend
together; however, try to make the two tones match as closely as possible.
8. Click
OK
to register the calibration setting.
9. Click
OK
to exit the setup program, then restart your Macintosh.
You will not need to change the screen calibration again as
long as you continue to use the same monitor. If you need to
recalibrate your screen at a later time, select Screen
Calibration in the EPSON Scanner folder.
before calibration
after calibration
To Next Page
