17
If You’re Running Windows 95 or Windows 98. . .
Depending on how your computer system was originally set up, you may be asked to
insert your Windows operating system CD-ROM during the scanner installation.
Please have your Windows CD-ROM handy, in case it is needed.
1. Turn on your scanner first; then turn on your computer. A screen appears saying
that your system has detected new hardware.
If your system doesn’t automatically detect the SCSI board,
run EZ-SCSI, a special Windows SCSI configuration utility.
Insert your EPSON Expression 800 Scanning Tools
CD-ROM in your drive. Click Start, then click Run. Type
D:\Adaptec\Ezscsi\Setup in the textbox (where D: is your
CD-ROM drive), then click OK.
2. Click Next. You see the screen to the
right.
3. Make sure Search for the best driver
for your device
is selected. Insert the
EPSON Expression 800 Scanning
Tools CD-ROM in the CD-ROM
drive, then click Next.
4. When you see the screen to the right
prompting you for the location of the
driver, deselect
Floppy disk drives
and check
Specify a location.
Then
use the Browse function to specify
either
D:\EPSON\Drivers\Win98
or
D:\EPSON\Drivers\Win95
(where
D:
is your CD-ROM drive).
To Next Page
Loading...
