Epson Expression 800 - Using the Film Guides

47
5. Insert the two installation
screws that came with the
transparency unit into the screw
holes, then tighten the screws
with a coin.
6. Gently close the transparency
unit.
7. Attach the transparency unit
connector to the OPTION
connector at the back of the
scanner. Tighten the attached
screws to secure the connector.
8. Plug the scanner back in and
turn it on.
If you haven’t connected the scanner to your computer, continue with “Connect
the Scanner to Your Computer” on page 15. Then turn on the scanner and
transparency unit.
For instructions on how to use the transparency unit, see your electronic EPSON
Expression 800 Reference Guide for transparency loading instructions, then refer to
“Step-by-Step Scanning Instructions” on page 35 of this guide for scanning
instructions. For more detail, see your electronic EPSON TWAIN Pro User’s Guide or
LaserSoft SilverFast Lite User’s Guide.
Using the Film Guides
You can use the four film guides that came with the TPU to scan 35 mm slides, strips
of 35 mm negative or positive film, 120-size or 220-size format film, and 4
×
5
-inch
film.
0
1
2
3
4
5
6
7
SCSI
ID
OPTION
TERMINATOR
SW
LOCK
UNLOCK
ON
O
FF
OPTION