52
Installing the Auto Document Feeder
Don’t remove the protective foam block from the mounting hardware until you’ve
finished installing the auto document feeder.
Follow the steps below to install the auto document feeder on your scanner.
1. Make sure your scanner is turned
off and unplug the cables.
2. Remove your scanner’s document
cover by grasping the back of
the cover as shown and easing the
cover up.
3. Make sure the document table is
clean and dust free.
4. Position the auto document
feeder’s mounting slots over
the two mounting screws
located at the back of the
scanner. Slide the auto
document feeder forward
slightly until the two holes in
front of these slots are aligned
with the screw holes at the
back of the scanner.
don’t remove the foam
block until you’re done
installing the unit
To Next Page
Loading...
