192 Options and Consumables
R4CC530
long.bk Rev. E
A5 size OPT.fm
6/23/03
L
Proof Sign-off:
ABE J. Hashimoto, S. Yamamoto
H. Kimura
S. Halvorson
2. If you are using ordinary single-sheet paper, set the
paper-thickness lever (located under the printer cover) to 0 as
shown below.
If you are loading a single-sheet multipart form, set the
paper-thickness lever to the proper position, as shown in the
table below.
3. Turn on the printer, if necessary.
4. Slide the left edge guide to the triangle mark on the front
paper or front sheet guide. Then adjust the right edge guide
to match the width of your paper.
Multipart form type Paper-thickness lever position
2 parts (original + 1 copy) 1
3 parts (original + 2 copies) 3
4 parts (original + 3 copies) 5
5 parts (original + 4 copies) 6
6 parts (original + 5 copies) 7
To Next Page
Loading...
