114 Control Panel
R4CC530
long.bk Rev. E
A5 size CP.fm
6/23/03
L
Proof Sign-off:
ABE J. Hashimoto, S. Yamamoto
H. Kimura
S. Halvorson
Selecting a Font and Pitch
You can select one of the printer’s five fonts and pitch by using
the buttons on the printer’s control panel, as described below.
Note:
❏ Settings you make in application programs usually override settings
you make from the printer’s control panel. For best results, use your
application to select a font and make other settings.
❏ The available pitch depends on the font you select. See the table below
for more information.
12 Pause button
❏ Stops printing temporarily, and resumes printing
when pressed again.
❏ When held down for three seconds, enters the
Micro Adjust mode. When pressed again, exits the
Micro Adjust mode.
13 Paper Out light
❏ On when no paper is loaded in the selected paper
source or paper is not loaded correctly.
❏ Flashes when paper has not been fully ejected or a
paper jam has occurred.
Font Pitch
USD 10, 12
HSD 10, 12, 15, 17, 20
Draft 10, 12, 15, 17, 20, PS
To Next Page
Loading...
