Epson LX-810 User Manual

Replacing the Ribbon
5. To remove excess slack in the new ribbon, turn the ribbon-
tightening knob in the direction of the arrow.
6. Push the new ribbon cartridge firmly into position, making sure ^
the plastic hooks fit into the slots, as shown below.
Note: Press lightly on both sides of the cartridge to make sure
the hooks are properly inserted.
6-6 Maintenance

Epson LX-810 Specifications

General

Print Method	Impact dot matrix
Number of Pins	9
Character Sets	96 characters (USASCII)
Line Spacing	1/6 inch
Paper Path	Rear
Interface	Centronics parallel
Noise Level	55 dB (A)