107
Maintenance
1
Turn the product off.
See “Turning Off the Power” on page 20.
2
After the Power light goes off, disconnect the power cord and USB cable.
3
For PP-100II, remove drive 1 and drive 2.
For the procedure, see the instruction manual of the drive.
4
Attach protective materials to the arm, and secure them with tape.
5
Attach Stacker 1, Stacker 2, and Stacker 3 (only for PP-100II/PP-100/PP-100AP), and
secure them with tape.
6
Open the ink cartridge cover, and secure the ink cartridges with tape.
7
Close the ink cartridge cover, disc cover, and Stacker 4 (only for PP-100II/PP-100/
PP-100AP), and secure them with tape.
8
With the bottom of the product facing downwards, place the product into the packing box
so that it is oriented horizontally.
To Next Page
Loading...
