71
Publishing Discs
Taking out discs
When the publishing process finishes, follow the steps below to take out published discs.
For PP-100II/PP-100/PP-100AP
The stacker used as the output stacker differs depending on the publish mode. Confirm the output stacker in the
following table.
1
Only when the output stacker is Stacker 2 or Stacker 3, open the disc cover and take it out.
For precautions when you open the disc cover, see “Opening the Disc Cover” on page 21.
2
Take out the published discs from the stacker.
Publish Mode Output Stacker Number of Discs
Standard mode
(when the output stacker is set to Stacker 2)
Stacker 2 Up to approximately 50 discs
Standard mode
(when the output stacker is set to Stacker 4)
Stacker 4 Up to approximately 5 discs
External Output mode
(when the output stacker is set to Stacker 3)
Stacker 3 Up to approximately 50 discs
External Output mode
(when the output stacker is set to Stacker 4)
Stacker 4 Up to approximately 5 discs
Batch mode Stacker 2 Up to approximately 50 discs
Stacker 3 Up to approximately 50 discs
• After printing on the label surface, allow EPSON specified CDs/DVDs to dry for at least
one hour, and other types of discs for at least 24 hours. Do not insert discs into a drive or
other device until they are completely dry.
• Avoid drying under direct sunlight.
• Directly touching or moisture getting on the label surface before or after printing may
result in blurring or discs sticking together.
To Next Page
Loading...
Need help?
General
