29
Software Settings
The Properties screen appears.
4
Set Stacker Settings, Drive Settings (only for PP-100II/PP-100/PP-50), and Printer
Settings (only for PP-100II/PP-100/PP-50).
See EPSON Total Disc Utility Help for details.
5
Click OK.
• Setting the most suitable publish mode for the usage or number of discs to be
published enables efficient disc publishing. (See “Selecting Publish Mode” on page 57.)
• Setting the Number of Write Retries enables a job to be executed again without job
processing pausing even if an error occurs during writing. The error disc is output to the
output stacker.
• The error mark will not be printed in the following cases.
∗ The job was cancelled
∗ An incorrect disc type was found in the input stacker
∗ Not enough ink was left to print the error mark
∗ Fatal error
• For PP-100II/PP-100
Error discs are ejected to:
∗ Stacker 4 in Standard mode
∗ Stacker 3 or Stacker 4 in External Output mode
∗ Stacker 2 or Stacker 3 in Batch mode
• For PP-50
Error discs are ejected to Stacker 3.
• For EPSON Total Disc Utility Help, see “EPSON Total Disc Utility Help” on page 39.
To Next Page
Loading...
Need help?
General
