EasyManuals Logo

Epson RC700-A Original Instructions

Epson RC700-A
228 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #76 background imageLoading...
Page #76 background image
Installation 3. Power-ON
58 RC700 Series Rev.3
3.2 Power ON Procedure
(1) Check the M/C power cable connection.
(2) Check the M/C signal cable connection.
(3) Check the EMERGENCY connector connection.
(4) Connect the TP bypass plug to the TP port of the Robot Controller.
(5) Connect the AC power cable to the power supply socket.
(6) When you use Drive Unit:
Check the Control Unit and Drive Unit connection.
Turn ON the Drive Unit POWER switch.
(6) POWER Switch
(7) Turn ON the POWER switch of the Control unit.
(8) 7 Segment LED
(7) POWER Switch
(8) The seven-segment LED blinks as approximately 30 seconds after
Control unit starts up normally.
If an error is displayed, check connection in step (1) to (5) and turn ON the power
again.
If an error is displayed after checking the connection, contact the supplier in your
region.

Table of Contents

Other manuals for Epson RC700-A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson RC700-A and is the answer not in the manual?

Epson RC700-A Specifications

General IconGeneral
BrandEpson
ModelRC700-A
CategoryController
LanguageEnglish

Related product manuals