Epson SC-R5000 Series User Manual

J
K
Note:
If the roll of media has an outer diameter which
is less than 140 mm (5.5 inches), the roll core will
not reach the media holder when raised using the
lift lever.
Raise it with your hands, and insert the roll core
onto the media holder.
L
To ensure the media holder is inserted into the
roll core sufficiently, push it twice.
c
Important:
If the media holder is inserted into the roll
core insufficiently, media is not fed correctly
during printing because of slippage between
the media holder and the roll core.
This may cause banding in the print results.
M
Tighten the screw until the screw no longer turns.
c
Important:
❏ If the media holder screw is loose, the
media holder may move during printing.
This could cause stripes and unevenness
in the print results.
❏ If the right and left edges of the roll are
not aligned, realign them.
SC-R5000 Series/SC-R5000L Series User's Guide
Basic Operations
50

Epson SC-R5000 Series Specifications

General

Brand	Epson
Model	SC-R5000 Series
Category	Printer
Language	English