Epson Stylus Photo 925 - Page 141

EPSON Stylus Photo 925 Revision A
Maintenance Overview 141
8 <Lubrication Point>
• Shaft for the combination gear 9.6, 24 on the ink system
frame
See Figure 6-9. "Lubrication point 8".
<Lubrication Type>
•G-26
<Lubrication Amount>
• φ2mm x 5mm
• Lubricate with a
dropping pipet.
9 <Lubrication Point>
• Shaft for the combination gear 13.6, 33 located
in the left area of the printer
See Figure 6-10. "Lubrication point 9"
<Lubrication Type>
•G-26
<Lubrication Amount>
•5mm
• Lubricate with a
dropping pipet.
10 <Lubrication Point>
• Shaft for the combination gear 47, 19.2 located in the
left area of the printer
See Figure 6-11. "Lubrication point 10"
<Lubrication Type>
•G-26
<Lubrication Amount>
• φ1mm x 2mm
• Lubricate with a
dropping pipet.
11 <Lubrication Point>
• Projection on the gear (spur gear 19.2/13.6) of the
cutter mechanism which comes in contact with the
frame
See Figure 6-12. "Lubrication point 11".
<Lubrication Type>
•G-26
<Lubrication Amount>
• φ1mm x 2mm
• Lubricate with a
dropping pipet.
Table 6-2.Lubrication Point (continued)
NO. Lubrication Type/Point Remarks
12 <Lubrication Point>
• Inside the bore of the right bushing for the paper
eject roller
See Figure 6-13. "Lubrication point 12".
<Lubrication Type>
•G-26
<Lubrication Amount>
•2 turns
• Apply with a brush.
13 <Lubrication Point>
• Part of the PF Roller and Grounding Spring where
they come in contact with each other
See Figure 6-14. "Lubrication point 13".
<Lubrication Type>
•G-26
<Lubrication Amount>
• φ1mm x 10mm
• Lubricate with a
dropping pipet.
• Do not apply grease
to the paper path.
14 <Lubrication Point>
• Inside the bore of the right bushing for the PF Roller
See Figure 6-15. "Lubrication point 14".
<Lubrication Type>
•G-26
<Lubrication Amount>
• φ3mm
• Apply with a brush.
Table 6-2.Lubrication Point (continued)
NO. Lubrication Type/Point Remarks