Epson Stylus Photo 925 - Page 92

EPSON Stylus Photo 925 Revision A
Disassembly and Assembly Disassembly 92
Figure 4-37. Installing the LD roller shaft holder
T Before installing the LD Roller, make certain that the projection
of the LD Roller is fit in the round hole of the clutch as shown
below.
Figure 4-35. Assembling the Clutch Mechanism
Round hole in the Clutch
Protrusion on the LD Roller Shaft
T When connecting the cable to the connector of the PE Sensor,
fasten the cable to the LD Roller Shaft Holder as shown below.
Figure 4-36. Installing the PE sensor cable
T When installing the LD Roller Shaft Holder on the printer
mechanism, set the Change Lever to front and place the paper
return side in the ASF Frame.
T Make certain that the cut side of the LD Roller faces inside.
PE Sensor Cable
Change Lever
Paper return side