Epson Stylus Photo 925 - Page 97

EPSON Stylus Photo 925 Revision A
Disassembly and Assembly Disassembly 97
T When installing the Torsion Spring 32.7, make sure that the
spring is set properly in the grooves of the ASF Frame and Pad
Holder and the Pad Holder moves smoothly.
T To secure the ASF Unit to the printer body, tighten the screws in
the numerical order as shown below.
Figure 4-49. Order in which the Screws for ASF Unit are to be
tightened
T Tightening torque for screws
• Two screws securing the ASF Unit:
C.B.S. TITE, 3x6, F/ZN : 8 ~ 10kgf.cm
C.B.S. TITE (P4),3x6, F/ZN : 8 ~ 10kgf.cm
A D J U S T M E N T
R E Q U I R E D
T When the ASF Frame and ASF Hopper are to be replaced with
new ones, be sure to apply an appropriate amount of grease G-26
to the specified points. Refer to
• Figure 6-5. “Lubrication point 4” in Chapter 6.
• Figure 6-6. “Lubrication point 5” in Chapter 6.
• Figure 6-7. “Lubrication point 6” in Chapter 6.
C.B.S. TITE, 3x6, F/ZN
C.B.S. TITE(P4), 3x6, F/ZN
2
1