Epson Stylus Pro 4000 - Page 147

Printing with Mac OS 8.6 to 9.x 147
4
4
4
4
4
4
4
4
4
4
4
4
Drying Time
per Print
Head Pass
Adds a waiting time when the print head reaches the end
of every pass.
Set this value using the slider or text box. To improve the
print quality by slow ink absorption on the media, set the
value larger.
The drying time per print head pass can be set in 0.1
second increments, from 0 to 5 seconds.
Note:
If you use this feature, printing time will be longer.
Paper Feed
Adjustment
Controls the paper feeding value in 0.01% increments. If
the paper feeding value is too large, white horizontal
micro banding may appear. If the paper feeding value
is too small, dark horizontal micro banding may appear.
Paper Suction Decreasing the air suction at the platen is useful to avoid
wrinkling or waving of thin or saturated media, or
eliminating vertical banding. The relationship of the
parameter and suction power is as follows.
Standard : 100 %
-1: 50 %
-2: 30 %
-3: 10 %
-4: 5 %
Paper
Thickness
This value automatically appears according to the media
for the Media Type setting. If you use non-Epson media,
modifying this value for your media is recommended.
Refer to the paper specifications or print "Thickness
Pattern" to find out the paper thickness.
Cut Method Determines the best cutting method according to the
paper thickness.
Standard: normal speed and normal cut pressure.
Thin Paper: low cut pressure.
Thick Paper, fast: high speed and high cut pressure.
Thick Paper, slow:low speed and high cut pressure.
Mode Description