148 Printing with Mac OS 8.6 to 9.x
Platen Gap Platen Gap is the height from the media loaded into the
printer to the print head. By adjusting this parameter, you
may produce better print quality. This is set automatically
according to the Paper Thickness specified.
Note:
Setting Platen Gap to Narrow may produce better print
quality, but make sure that the media does not wrinkle or
touch the print head. Otherwise, the printed data or the
print head surface may be damaged. Use Wider or
Widest in such case.
Eject Roller
Type
Select one that best fits your media.
Auto:
The printer selects the most appropriate setting
automatically. When you use Epson special media,
usually select this setting.
Starwheel-Sheet:
If you want to print on cut sheet which is non-Epson
special media, select this setting.
Starwheel-Roll Curled:
If you want to print on strongly curled roll paper which is
non-Epson special media, select this setting.
No Roller-Roll Normal:
If you want to print on roll paper which is non-Epson
special media, select this setting.
Mode Description
To Next Page
Loading...
