Epson Stylus Pro 4000 - Page 35

The Control Panel 35
1
1
1
1
1
1
1
1
1
1
1
1
2. Press the Menu button to enter SelecType mode.
3. Press the Paper Feed or Paper Feed button to display
HEAD ALIGNMENT, and press the Menu
button.
4. As PAPER THKNS is displayed, press the Menu
button.
5. Press the Paper Feed or Paper Feed button to select
STD or paper thickness value between 0.0mm and 1.6mm.When
you want to print on Epson special media, select STD. When
you want to print on non-Epson special media, enter the
thickness value of the paper.
6. Press the Menu
button to register your value.
7. Press the Menu
button again. ALINGMENT is displayed on
the upper row, and AUTO is displayed on the lower raw on the
LCD.
8. Press the Menu
button to select AUTO, and press the Paper
Feed or Paper Feed button to select BI-D BLACK.
If you are using Epson special media and want to perform
head alignment with all colors, select BI-D ALL.
9. Press the Menu
button, and the printer starts printing.
Head alignment pattern examples (BI-D BLACK):
If you are not satisfied with the printed pattern of the automatic
head alignment, you can perform the head alignment manually.
To perform head alignment manually, follow these steps.
1. Press the Menu
button to enter SelecType mode.