38 The Control Panel
Registering the settings
To register the paper settings, follow these steps.
1. Load the paper which you want to check.
2. Press the Menu
button to enter SelecType mode.
3. Press the Paper Feed or Paper Feed button to display
CUSTOM PAPER.
4. Press the Menu
button to display PAPER NUMBER.
5. Press the Menu
button, and press the Paper Feed or
Paper Feed button to select STANDARD or the number (No.
1 to No. 10) you want to register as the setting.
If you use Epson special media, select STANDARD, and skip to
the step 9. You do not have to make paper thickness setting
because STANDARD automatically determines paper thickness.
6. Press the Menu
button to display PLATEN GAP. Press the
Paper Feed or Paper Feed button to select NARROW,
STANDARD, WIDER, or WIDE.
7. Press the Menu
button to save the selected platen gap
setting, and THICKNESS PAT is displayed on the LCD.
8. Press the Menu
button again to print the paper thickness
test printing pattern.
Paper thickness test pattern example:
9. Examine the printed pattern to determine which set of lines
are aligned (show the smallest gap), and note the
corresponding number.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
smallest gap
To Next Page
Loading...
