Epson Stylus Pro 4000 - Managing Print Jobs on the RIP Server; Job Control and Modification

The Control Panel 39
1
1
1
1
1
1
1
1
1
1
1
1
10. After printing the pattern, THICKNESS NUM is displayed. Press
Paper Feed or Paper Feed button to select the number
noted in step 9.
11. Press the Menu
button to save the selected value.
12. CUT METHOD is displayed. Press the Paper Feed or Paper
Feed button to select STANDARD, THICK, SLOW, THICK,
FAST, or THIN PAPER, and press the Menu
button.
13. PPR FEED ADJ is displayed. Press the Paper Feed or Paper
Feed button to set the paper feed amount, and press the
Menu
button.
14. EJECT ROLLER is displayed. Select AUTO, SHEET, ROLL CURLED,
or ROLL NORMAL, and press the Menu
button.
15. DRYING TIME is displayed. Press the Paper Feed or Paper
Feed button to select time in seconds, and press the Menu
button.
16. SUCTION is displayed. Press the Paper Feed or Paper
Feed button to select either STANDARD, -1, -2, -3, or -4.
17. M/W ADJ is displayed. Press Paper Feed or Paper Feed
button to adjust MicroWeave. Increase the value to give
priority to printing speed. Decrease it to give priority to the
print quality.
18. Press the Menu
button to save the selected value.
Selecting the registered settings
To select the registered settings, follow these steps.
1. Press the Menu
button to enter SelecType mode.
2. Press the Paper Feed or Paper Feed button to display
CUSTOM PAPER, and press the Menu
button.