Epson STYLUS PRO 9400 - Page 264

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 264
8. Remove the screw that secures the IM Sensor and remove it.
 One C.P.P. M1.4 x 5 screw
9. Disconnect the FFC from the connector.
Figure 4-99. Removing the IM Sensor
Put the protrusion of the IM Sensor into the hole located under the
tab.
Figure 4-98. Reinstalling the IM Sensor
A D J U S T M E N T
R E Q U I R E D
Whenever the IM Sensor is reinstalled or replaced, the
corresponding adjustment must be carried out. See Chapter 5 on
page 292.
Tab
Protrusion
IM (Ink Mark) Sensor
Connector
FFC
C.P.P. M1.4x5