EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Troubleshooting Troubleshooting based on Panel Messages 172
3.2 Troubleshooting based on Panel Messages
The printer runs diagnostic checks on itself according to various conditions detected by sensors. If an error condition is detected as a result of the self-diagnosis, the printer displays
the corresponding error message on its LCD panel.
This section explains the error messages and provides remedies for them.
3.2.1 List of Panel Messages
The panel messages displayed by the printer are listed in the table below in the order of ascending priorities.
NOTE:
Messages in blue-colored rows are Warning messages, and those in yellow-colored rows are Service Call error messages.
Table 3-1. List of Panel Messages
Panel Message Printer Condition
LED Indication
Reference Pages
Power Pause Ink Check Paper Check
MAINTENANCE TANK
NEARLY FULL
The Maintenance Tank is in near full state. --- --- Flashing --- p.178
INK LOW The remaining amount of ink is low. *
1
--- --- Flashing --- p.178
PAPER OUT
LOAD PAPER
The printer run out out of paper. ON ON --- ON p.181
MAINTENANCE REQUEST
XXXX
A maintenance is required. --- --- --- Flashing*
2
p.178
PAPER LOW The remaining amount of loaded paper is low. --- --- --- Flashing p.180
CLEANING ERROR
REMOVE THICK PAPER
The printer cannot run a cleaning. ON ON --- ON p.181
CLEANING ERROR
PRESS PAUSE BUTTON
The printer failed to run a cleaning. ON ON --- Flashing p.181
SENSOR ERROR
LOAD DIFFERENT PAPER
The Ink-mark sensor caused a SN gain error (paper type
identification error).
ON ON --- Flashing p.181
PAPER EJECT ERROR
REMOVE PAPER FROM
PRINTER
The printer failed to eject paper. ON ON --- Flashing p.181
PAPER OUT
LOAD PAPER
The printer run out of roll paper. ON ON --- ON p.181
BORDERLESS ERROR
LOAD CORRECT SIZE
PAPER
The printer cannot perform borderless printing (no margin on all
sides) with the loaded paper because of the paper size.
ON ON --- Flashing p.182
Continued to the next page
To Next Page
Loading...
