Epson STYLUS PRO 9400 - 5.8 Model Setting (when replacing the Main Board)

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Adjustment Model Setting (when replacing the Main Board) 372
5.8 Model Setting (when replacing the Main Board)
 Preparation for the setting
 Devices
PC (The corresponding printer driver and STM must have been installed),
New Main Board (after service part)
 Programs
Adjustment Program, Transfer Tool (FWUpdate.exe), Latest firmware
(*.*UPG file)
 Printer
Ink cartridges, Waste Ink Pads and other consumables must have been
installed. There should be no errors indicated on the LCD Panel.*
Note "*": The consumables must be removed when writing on the new
NVRAM as is conventionally done.
 Procedure of the setting
1. Make a backup of the NVRAM on the printer. See Section 5.3.18 on page
338.
2. Replace the Main Board with a new Main Board. See Section 4.2.4.1 on page
232.
3. Turn the printer On and connect it with the PC using a USB cable.
3-1. Confirm that “UPDATE F/W” is displayed on the LCD panel.
4. Start up the Transfer Tool (FWPpdate.exe).
4-1. In the “Chose a port”, select a port followed by the connected printer
name in parentheses.
5. Send the latest firmware to the printer using the Transfer Tool.
6. “F/W UPDATING” is displayed on the LCD panel, and the printer
automatically reboots.
7. After the reboot, “NVRAM CLEAR OK” is displayed on the LCD. Press the
MENU button.
7-1. Turn the printer Off.
8. Reboot the printer in Serviceman Mode.
8-1. Write the backup data onto the new NVRAM using the Adjustment
Program.
C A U T I O N
The firmware comes in wide models (Stylus Pro 9400/9800) and
narrow models (Stylus Pro 7400/7800) versions. Be sure to send a
correct firmware.