Epson STYLUS PRO 9400 - T&B&S + 980 Mm Band Feed

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Adjustment Basic Adjustment 318
5.3.5 T&B&S + 980mm Band Feed
Paper feeding amount and the left, right, top and bottom margins can be adjusted using
this menu.
 Paper Used
 Size: 24” (Stylus Pro 7400/7800)
44” (Stylus Pro 9400/9800)
 Type: Doubleweight Matte Paper
 Specifications
 Top margin: 10 ± 5 mm
 Bottom margin: 14 ± 5 mm
 Side margin: 10 ± 5 mm
 980mm feed: 980mm ± 10 mm
 Procedure
1. Start up the Adjustment Program and select [T&B&S + 980mm Band Feed].
2. Click the [Print] button to print the adjustment pattern.
3. Referring to Figure 5-29, measure the distance of the following four points.
 Top margin
 Bottom margin
 Side margin
 Band-feed amount
4. Enter the values measured in Step 3 into the corresponding edit boxes. (The
words inside the parentheses indicate the names displayed on the screen.)
 Top margin (Top Margin)
 Bottom margin (Bottom Margin)
 Side margin (Side Margin Adjust)
 Band-feed amount (980mm Feed)
5. Click the [Write] button and then click the [Print] button to print the
adjustment pattern again.
6. Perform Step 3 and Step 4 and click the [Write] button.
7. After confirming that the all values are within the specified range, click the
[Finish] button.
If they are not, perform Step 3 to Step 5 again.
Figure 5-28. T&B&S (Roll Paper) + 980mm Band Feed Screen
C A U T I O N
Be sure to place the adjustment pattern print on a flat surface when
performing the measurement.