Epson STYLUS PRO 9400 - Front Cover Assy

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 230
4.2.3.9 FRONT COVER ASSY.
1. Open the FRONT COVER ASSY.
2. Remove the four screws that secure the FRONT COVER ASSY. and remove it
together with the two Reinforcing Hinges.
 Four C.C.S. M4 x 10 screws
Figure 4-34. Removing the FRONT COVER ASSY.
Make sure that the FRONT COVER, HINGE, L/R and the FRONT
COVER SPRING L/R are in the statuses shown in the figure below,
and then install the FRONT COVER ASSY.
Figure 4-33. Checking the FRONT COVER, HINGE and FRONT
COVER SPRING
Right Side of the Printer
Left Side of the Printer
FRONT COVER,
HINGE, R
FRONT COVER,
HINGE, L
FRONT COVER
SPRING L
FRONT COVER
SPRING R
C.C.S. 4x10
Reinforcing Hinge
C.C.S. 4x10
Reinforcing Hinge
FRONT COVER ASSY.