Epson STYLUS PRO 9400 - Page 231

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 231
4.2.3.10 Front Sensor
1. Open the FRONT COVER ASSY.
2. Remove the screw that secures the FRONT SENSOR COVER. See Figure 4-36.
 One C.C.S. M3 x 8 screw
3. Release the tab that secures the FRONT SENSOR COVER and turn it in the
direction shown in the figure. See Figure 4-36.
4. Release the two hooked tabs that secure the FRONT SENSOR and remove it. See
Figure 4-37.
5. Remove the connector from the FRONT SENSOR. See Figure 4-37.
Figure 4-36. Removing the FRONT SENSOR COVER
Figure 4-37. Removing the FRONT SENSOR
 Set the guide pin of the FRONT SENSOR COVER into the
positioning hole on the frame.
 Insert the tab of the FRONT SENSOR COVER into the slot of
the frame.
Figure 4-35. Reinstalling the FRONT SENSOR COVER
Guide Pin
Tab
FRONT SENSOR COVER
C.C.S 3x8
Tab
Left Side of the Printer
Connector
Hooked tabs
FRONT SENSOR