Epson STYLUS PRO 9400 - Page 288

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 288
4.2.7.6 BOX ASSY., FLUSHING (R, L)
BOX ASSY., FLUSHING (R)
1. Remove the R SIDE COVER ASSY. See Section 4.2.3.4 on page 223.
2. Remove the 2 screws that secure the BOX ASSY., FLUSHING (R).
 Two C.P.S.(S-P2) M3 x 8 screws
3. Pull out the TUBE, INK, WASTE; R from the Ink Exhaust through the two holes
of the frame, and remove the BOX ASSY., FLUSHING (R).
Figure 4-142. Removing the BOX ASSY., FLUSHING (R)
C A U T I O N
When removing the BOX ASSY., FLUSHING (R/L), ink may leak
out of the Waste Ink Tubes and the Ink Exhaust. Have a waste cloth
beforehand to wipe out the leaked ink.
C A U T I O N
When performing the next step, be careful not to damage the
SCALE, CR.
C A U T I O N
When reinstalling the TUBE, INK, WASTE; R, make sure to insert
it correctly into the waste ink outlet and route the tubes as shown in
the figure right, or ink may leak.
Right Rear of the Printer
TUBE, INK,
WASTE; R
Ink Exhaust
Holes
BOX ASSY.,
FLUSHING (R)
Right Front of the Printer
SCALE, CR
C.P.S.(S-P2) 3x8