Epson STYLUS PRO 9400 - Page 356

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Adjustment Basic Adjustment 356

Writing Color ID (at repair work site)
1. Start the adjustment program and select [Colorimetric Calibration ID].
2. Click [Run] to start “Colorimetric Calibration Tool”.
3. Click [Write Color ID].
4. Perform Step 5 to 6 of “Adjustment Procedure (Entire Process Workflow)” to check
the connection status to the printer.
5. Select [File] from “Input Method”.
6. Click [Specify the file], select the color ID data file (dat format), and click [Next].
7. Make sure that the S/N shown in the input data is the same as that of the connected
printer and that it should be the same as the product number of the printer. Click
[Next].
8. When the writing is complete, click [End].
Figure 5-85. Writing Colorimetric Calibration ID