B September 2, 2005 [Chapter 5]
• Descriptions have been added in Table 5-1. Parts and Units that Require Adjustments (Page 293).
• Descriptions have been added in Table 5-2. Required Adjustments in the Order of Execution (Page 294).
• Descriptions have been added in Basic Adjustment (Page 297).
• Made changes in Table 5-3. Tools for Adjustments (Page 299).
• Made changes in “System Requirements” in 5.1.7 Adjustment Program Basic Operations (Page 300).
• Made changes in 5.2.2 Cutter Position/Height Adjustment (Page 302).
• Made changes in 5.2.3 Paper Thickness Sensor Position Adjustment (Page 304).
• “Shield Cap” has been changed to “Seal Cap” in 5.2.8 Air Leak Check (Page 310).
• Made changes in 5.3.4 T&B&S (Roll Paper) (Page 316).
• Made changes in 5.3.5 T&B&S + 980mm Band Feed (Page 318).
• Made changes in 5.3.7 Nozzle Bi-D Adjustment (Page 321).
• Made changes in 5.3.8 Print Head Slant Adjustment (PF) (Page 322).
• Made changes in 5.3.9 Print Head Slant Adjustment (CR) (Page 325).
• Made changes in 5.3.10 Ink Mark Sensor Level Adjustment (Page 328).
• Made changes in 5.3.11 Auto Uni-D Adjustment (Page 329).
• Made changes in 5.3.12 Auto Bi-D Adjustment (P.G. 0.8/1.6) (Page 330).
• Made changes in 5.3.13 Ink Mark Sensor Adjustment for Auto Nozzle Check (Page 331).
• Made changes in 5.3.14 Skew Check (Page 333).
• Made changes in 5.3.15 Platen Position Adjustment (Page 334).
• Made changes in 5.3.16 980mm Band Feed Adjustment (Page 336).
• 5.3.22 Colorimetric Calibration (Color ID) (Page 341) have been added.
• Made changes in 5.4.1 Auto Bi-D Adjustment (Page 357).
• Made changes in 5.4.2 Manual Bi-D Adjustment (Page 358).
• Made changes in 5.5.1 Check Nozzle (Page 362).
• Made changes in 5.5.2 Check Alignment (Page 363).
• Made changes in 5.5.3 Print Adjustment Check Pattern (Page 364).
• Made changes in 5.5.4 Check Cutting (Page 365).
• 5.8 Model Setting (when replacing the Main Board) (Page 372) have been added.
To Next Page
Loading...
