Epson STYLUS PRO 9400 - Page 63

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Product Description Control Panel 63
The following 5 positions are available in the actual platen gap setting.
 Platen Gap Determining Sequence
The following flowchart shows the sequence to determine the platen gap.
 Platen Gap Setting menu
Table 1-39. Actual Platen Gap Setting
Position Gap width Use
Maximum 2.6mm For thick paper
Big 2.1mm Reduce the smearing on the printed image of thin paper.
Middle 1.6mm For certain easy-rubbed thin paper (Default)
Small 1.2mm For thin paper (Default)
Minimum 0.8mm For thin film (Film, glossy media)
Start
Is custom paper set?
Received by
RM command?
PG used by media ID
PG used by custom paper
setting
PG used by RM command
Printer reflects PG set
value
Determination by thick
paper sensor
End
Setting
Setting
Setting
Setting
Setting
PRINTER SETUP
PLATEN GAP
PAGE LINE
INTERFACE
PLATEN GAP
NARROW
STANDARD
WIDE
PLATEN GAP
STANDARD
WIDE
WIDER
PLATEN GAP
WIDE
WIDER
WIDEST
PLATEN GAP
WIDE
WIDER
WIDEST
PLATEN GAP
NARROW
STANDARD
WIDE