EPSON Stylus CX7300/CX7400/DX7400/NX200/TX200 series/SX200 series/Stylus CX8300/CX8400/DX8400/NX400/TX400 series/SX400 series Revision C
PRODUCT DESCRIPTION Control Panel 28
Confidential
1.6.2.3 Control Panel Power Saver Mode
If no operation is made on the control panel for approximately 13 minutes, both the
CX8300/TX400 series and CX7300/TX200 series automatically enter control panel
power saver mode. The details of control panel power save mode are shown below.
Conditions for not entering the control panel power save mode
• The printer or scanner is in operation
• During printing or scanning from PC
• Camera direct is in operation
• Slide show is being displayed
• An error is being displayed
• Mechanical adjustment is being made in setup mode
• Firmware is being updated
Conditions recovering from the control panel power save mode
• Any button other than the power button is pressed (when the power button is
pressed, the power is turned OFF)
• A memory card or a camera direct device is connected
• Operation from PC (printing / scanning / maintenance)
NOTE: See “ 1.7.3.4 Operating Specifications during Connecting DSC ( p. 37 ) ”
for information on the panel operation during connecting a camera to the
EXT.IF.
To Next Page