Epson Stylus TX209 User Manual

EPSON Stylus CX7300/CX7400/DX7400/NX200/TX200 series/SX200 series/Stylus CX8300/CX8400/DX8400/NX400/TX400 series/SX400 series Revision C
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 117
Confidential
4.5.9 PF Encoder Sensor
 Parts/Components need to be removed in advance
Document Cover/ASF Cover/Scanner Unit/Panel Unit/Upper Housing/Card Slot
Cover/Lower Housing/Main Board Unit/Left Frame
 Removal procedure
1. Peel off the acetate tape (x1) from the PF Encoder Sensor.
2. Release the PF Encoder FFC from the connector (x1) of the PF Encoder
Sensor.
3. Remove the screw (x1) that secures the PF Encoder Sensor, and remove the
PF Encoder Sensor.
Figure 4-58. Removing the PF Encoder Sensor
 When installing the EJ Roller, pay attention to the following
instructions.
• Make sure that the rubber part of the EJ Roller does not
contact with the hook of the Front Paper Guide.
• Be cautious not to touch the rubber part of the EJ Roller.
• Be sure to align the rib (x1) of the Front Paper Guide with
the slit on the EJ Roller.
Figure 4-56. Installing the EJ Roller
 When installing the Spur Gear 51.5, be sure to align the
concave section of it with the convex section of the EJ Roller.
Figure 4-57. Installing the Spur Gear 51.5
A D J U S T M E N T
R E Q U I R E D
 Whenever the EJ Roller is removed/replaced, the required
adjustments must be carried out.
• Chapter 5 “ ADJUSTMENT” (p.141)
 After replacing the EJ roller, be sure to perform the required
lubrication.
• Chapter 6 “ MAINTENANCE” (p.151)
Rib and Slit
Concave and Convex Section
Spur Gear 51.5
EJ Roller
Acetate tape
PF Encoder FFC
C.B.P. 2.5x8, F/Zn-3C (4±1kgfcm)
PF Encoder Sensor

Epson Stylus TX209 Specifications

General

Brand	Epson
Model	Stylus TX209
Category	Printer
Language	English