Epson TM-C7500 Series

204
When "Borderless Printing" is enabled
Ver tical margins: 0 mm (Typical value)
Lateral margins: 0 mm (Typical value)
 If you enabled “Extend Printable Area”, printing is done with settings for no margins, but the
printing might protrude beyond the paper/ label, depending on the actual print position and
the set position for the paper/ label. To make sure printing doesn’t protrude out, ensure
margins of 1.5 mm {0.06"} or more in the print data.
 The distance from the paper cut position to the black mark leading edge must be at least 1.5
mm {0.06"}. If it is less than 1.5 mm {0.06"}, the printer may be unable to print pages
because it fails to sense their black marks or skips them, etc.
Black mark position
Paper
Label area
Print area
Print area width
Paper width
Paper feeding
direction
Issuing pitch (Ph)
Interval of perforated lines (Pm)
Auto-cut position
Auto-cut position
Perforated line
Auto-cut position
Perforated line
Outer edge
(Removed)
2.0 mm { }
0.08”
Outer edge
(Removed)
2.0 mm { }
0.08”
1.5 to 3.0 mm { }
0.06 to 0.12”
1.5 to 3.0 mm { }
0.06 to 0.12”
0.5 to 1 mm { }
0.02 to 0.04”
1.5 to 3.0 mm { }
0.06 to 0.12”
25.4 mm { } or more
1.0”
28.4 mm { } or more
1.12”