Epson VT6L User Manual

Setup & Operation 7. Development PC Connection Port
70 VT Rev.1
(7) After the development PC and the Manipulator connection has completed, “Connected”
is displayed at [Connection status]. Make sure that “Connected” is displayed and
click the <Close> button to close the [PC to Controller Communications] dialog.
The connection between the development PC and the Manipulator is completed. Now
the robot system can be used from EPSON RC+ 7.0.
7.4 Disconnection of Development PC and Manipulator
Disconnection of the development PC and the Manipulator communication.
(1) Select the EPSON RC+ 7.0 menu-[Setup]-[PC to Controller Communications] to
display the [PC to Controller Communications] dialog.
(2) Click the <Disconnect> button.
Communication between the Manipulator and the development PC is disconnected
and the USB cable can be removed.
If the USB cable is removed when the Manipulator and the development PC are connected,
the Manipulator will stop. Be sure to click the <Disconnect> button in the [PC to
Controller Communications] dialog before USB cable is removed.

NOTE

Epson VT6L Specifications

General

Brand	Epson
Model	VT6L
Category	Robotics
Language	English